Height Control Sensor: Installation

WARNING: This page is about a different car, the 2008 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL HEIGHT CONTROL SENSOR SUB-ASSEMBLY REAR RH
1. Install the height control sensor link rear RH with the 2 nuts.
  Torque: 8.0 N*m (81 kgf*cm, 71 in.*lbf)
  
  Fig 1: Locating Height Control Sensor Rear RH Nuts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Align the matchmarks with the one on the height control sensor sub-assembly rear RH and bracket.
3. Install the height control sensor sub-assembly rear RH.
  Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
4. Connect the connector.
5. Install a nut.
6. When the work like the vehicle height may be changed is performed, for example, removal and installation of the height control sensor, or replacement of the suspension, etc., initialize the sensor, then adjust the optical axis (See INITIALIZATION ).
VEHICLE PREPARATION FOR HEADLIGHT AIM ADJUSTMENT (See ADJUSTMENT )
PREPARATION FOR HEADLIGHT AIMING (Using a tester) (See ADJUSTMENT )
PREPARATION FOR HEADLIGHT AIMING (Using a screen) (See ADJUSTMENT )
HEADLIGHT AIMING INSPECTION (See ADJUSTMENT )
HEADLIGHT AIMING ADJUSTMENT (See ADJUSTMENT )