Inspection Procedure

WARNING: This page is about a different car, the 2008 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.

INSPECT GATEWAY ECU

Disconnect the gateway ECU connector E23.

Measure the resistance according to the value(s) in the table below.

Standard resistance

TESTER CONNECTION SPECIFIED CONDITION CHART

Tester connection	Condition	Specified condition
GND - Body ground	Always	Below 1 Ω

Measure the voltage according to the value(s) in the table below.

Standard voltage

TESTER CONNECTION SPECIFIED CONDITION CHART

Tester connection	Condition	Specified condition
BATT - GND	Always	10 to 14 V
ACC - GND	Ignition SW on (ACC)	10 to 14 V
IG - GND	Ignition SW on (IG)	10 to 14V

Fig 1: Disconnecting Gateway ECU Connector E23

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR

OK : PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE