FixVault
Home › Toyota › 2009 › Camry Base, Standard › Repair and Diagnosis › Brakes › Traction Control › Brake Control - Except Hybrid › Skid Control Sensor › Removal

Skid Control Sensor: Removal

  1. REMOVE REAR WHEEL 

    HINT:

    • Use the same procedure for the RH side and LH side.
    • The procedures listed below are for the LH side.
  2. DISCONNECT SKID CONTROL SENSOR WIRE 
    1. Disconnect the connector from the skid control sensor.
      NOTE: Be careful not to damage the speed sensor.
    Fig 1: Locating Skid Control Sensor Connector
    G04978260Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. REMOVE REAR DISC BRAKE CALIPER ASSEMBLY  (See REMOVAL )
  4. REMOVE REAR DISC  (See DISASSEMBLY )
  5. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY WITH SKID CONTROL SENSOR  (See REMOVAL )
  6. REMOVE SKID CONTROL SENSOR 
    1. Mount the rear axle hub in a vise using aluminum plates.
      NOTE: Replace the hub and bearing assembly if it is dropped or receives a strong shock.
    2. Using a pin punch and hammer, drive out the 2 pins and remove the 2 attachments from SST.

      SST 09520-00031 (09521-00010,09520-00040), 09521-00020 

    3. Using SST and 2 bolts (Diameter: 12 mm, pitch: 1.5 mm), remove the skid control sensor from the hub and bearing assembly.

      SST 09520-00031 (09521-00010,09520-00040), 09521-00020,09950-00020 

      NOTE:
      • Keep the sensor away from magnets.
      • Pull the skid control sensor off straight, taking care not to make contact with the skid control sensor rotor.
      • If the speed sensor rotor is damaged or deformed, replace the hub and bearing assembly.
      • Do not scratch the contact surface between the axle hub and the skid control sensor.
      • Do not attach foreign matter to the speed sensor rotor and tip.
        Fig 2: Removing Skid Control Sensor Using SST
        G04978261Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
About FixVault