FixVault
Home › Toyota › 2009 › Camry Base, Standard › Repair and Diagnosis › Engine Performance › Engine Control System (2AZ-FE) (Except Hybrid) › Crankshaft Position Sensor › Installation

Crankshaft Position Sensor: Installation

  1. INSTALL CRANKSHAFT POSITION SENSOR 
    1. Apply a light coat of engine oil to the O-ring on the crankshaft position sensor.
      Fig 1: Identifying Crankshaft Position Sensor O-Ring
      G04973362Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Install the crankshaft position sensor with the bolt.

      Torque: 9.0 N*m (92 kgf*cm, 80 in.*lbf) 

    3. Connect the crankshaft position sensor connector.
    Fig 2: Identifying Wire Harness Clamp Bracket
    G04973363Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL GENERATOR ASSEMBLY  (See INSTALLATION )
  3. INSTALL V-RIBBED BELT  (See INSTALLATION )
  4. INSTALL FRONT FENDER APRON SEAL RH 
  5. INSTALL FRONT WHEEL RH 
  6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
About FixVault