Engine Control System (2AZ-FE) (Except Hybrid): ECM: Removal

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY (See REMOVAL )
REMOVE AIR CLEANER INLET ASSEMBLY (See REMOVAL )
REMOVE AIR CLEANER CAP SUB-ASSEMBLY (See REMOVAL )
REMOVE AIR CLEANER CASE SUB-ASSEMBLY (See REMOVAL )
REMOVE AIR CLEANER BRACKET
1. Remove the 2 bolts and air cleaner bracket.
  
  Fig 1: Locating Air Cleaner Bracket Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
DISCONNECT ECM CONNECTOR
1. Disconnect the 2 ECM connectors.
  1. Raise the levers while pushing the locks on the levers, and disconnect the 2 ECM connectors.
    NOTE: After disconnecting the connector, make sure that dirt, water and other foreign matter does not contact the connecting part of the connector.
    
    Fig 2: Disconnecting ECM Connector
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE ECM
1. Remove the 3 bolts of the ECM with bracket.
  
  Fig 3: Locating ECM Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the ECM with bracket.
3. Remove the 4 screws and ECM bracket.
  
  Fig 4: Locating ECM Bracket Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002