FixVault
Home › Toyota › 2009 › Camry Hybrid › Repair and Diagnosis › Engine Performance › Engine Control System (Hybrid) › Crankshaft Position Sensor › Installation

Crankshaft Position Sensor: Installation

  1. INSTALL CRANKSHAFT POSITION SENSOR 
    1. Apply a light coat of engine oil to the O-ring on the crankshaft position sensor.
      Fig 1: Identifying Crankshaft Position Sensor O-Ring
      G04973362Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Install the crankshaft position sensor with the bolt.

      Torque: 9.0 N*m (92 kgf*cm, 80 in.*lbf) 

      Fig 2: Locating Crankshaft Position Sensor Bolt
      G05007999Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Connect the crankshaft position sensor connector.
  2. INSTALL ELECTRIC INVERTER COMPRESSOR  (See INSTALLATION )
  3. CONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE  (See INSTALLATION )
  4. CONNECT NO. 1 COOLER REFRIGERANT SUCTION HOSE  (See INSTALLATION )
  5. CONNECT RADIATOR HOSE OUTLET  (See INSTALLATION )
  6. INSTALL V-RIBBED BELT TENSIONER ASSEMBLY  (See INSTALLATION )
  7. INSTALL V-RIBBED BELT  (See INSTALLATION )
  8. INSTALL V-RIBBED BELT TENSIONER COVER SUB-ASSEMBLY  (See INSTALLATION )
  9. INSTALL SERVICE PLUG GRIP  (See INSTALLATION )
  10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  11. ADD ENGINE COOLANT (for Engine)  (See COOLANT (FOR ENGINE) )
  12. INSPECT FOR COOLANT LEAK (for Engine)  (See ON-VEHICLE INSPECTION )
  13. CHARGE WITH REFRIGERANT  (See REPLACEMENT )
  14. WARM UP COMPRESSOR  (See REPLACEMENT )
  15. INSPECT FOR REFRIGERANT LEAK  (See REPLACEMENT )
  16. PERFORM INITIALIZATION 
    1. Perform initialization procedure (See INITIALIZATION ).
    NOTE: Some vehicle systems require initialization after reconnecting the cable to the negative battery terminal.
About FixVault