Inspection Procedure

CHECK DTC

Clear the DTCs (See DTC CHECK/CLEAR ).
Perform a road test.
Check if the same DTC is recorded (See DTC CHECK/CLEAR ).

Result

RESULT CHART

Result	Proceed to
DTC (C1440) is output	A
DTC (C1440) is not output	B
Yaw rate and acceleration sensor DTC is output	C

B: END

C: REPAIR CIRCUIT INDICATED BY OUTPUT DTC (See DIAGNOSTIC TROUBLE CODE CHART )

A: Go to next step

CLEAR DTC
1. Clear the DTCs (See DTC CHECK/CLEAR ).
HINT:
- If the skid control ECU determines that the vehicle is being driven at a steep bank angle, the skid control ECU stores DTC C1440 while VSC operation is temporarily disabled.
- It is not a malfunction if the system and sensor circuits are normal and if the normal VSC operation resumes.
NEXT: END