FixVault
Home › Toyota › 2009 › Highlander Limited, AWD › Repair and Diagnosis › Engine Performance › Fuel Delivery › Engine Fuel System (2GR-FE) › Fuel Injector › Installation

Fuel Injector: Installation

  1. INSTALL FUEL INJECTOR ASSEMBLY 
    1. Apply a light coat of spindle oil or gasoline to new O-rings, and install them to each injector.
      NOTE: The wound or the foreign body must not adhere in the ditch of O-ring.
      Fig 1: Identifying O-Ring
      G04975017Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Apply a light coat of spindle oil or gasoline where the fuel delivery pipe contacts the O-ring.
    3. Push the fuel injector while turning it to install the injector in the fuel delivery pipe.
    4. Position the fuel injector connector outward.
      NOTE:
      • Be careful not to twist the O-ring.
      • After installing the fuel injector, check that it turns smoothly. If not, reinstall it with a new O-ring.
      Fig 2: Turning Fuel Injector
      G04975018Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL FUEL DELIVERY PIPE SUB-ASSEMBLY  (See INSTALLATION )
  3. CONNECT FUEL TUBE SUB-ASSEMBLY  (See INSTALLATION )
  4. TEMPORARILY INSTALL NO. 1 SURGE TANK STAY  (See INSTALLATION )
  5. TEMPORARILY INSTALL THROTTLE BODY BRACKET  (See INSTALLATION )
  6. INSTALL INTAKE AIR SURGE TANK ASSEMBLY  (See INSTALLATION )
  7. FULLY TIGHTEN NO. 1 SURGE TANK STAY  (See INSTALLATION )
  8. FULLY TIGHTEN THROTTLE BODY BRACKET  (See INSTALLATION )
  9. CONNECT ENGINE ROOM MAIN WIRE  (See INSTALLATION )
  10. INSTALL AIR CLEANER CAP SUB-ASSEMBLY  (See INSTALLATION )
  11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL  (See INSTALLATION )
  12. INSPECT SRS WARNING LIGHT  (See INSTALLATION )
  13. INSPECT FOR FUEL LEAK  (See ON-VEHICLE INSPECTION )
  14. ADD ENGINE COOLANT  (See REPLACEMENT )
  15. INSPECT FOR ENGINE COOLANT LEAK  (See COOLING SYSTEM )
  16. INSTALL V-BANK COVER SUB-ASSEMBLY  (See INSTALLATION )
  17. INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY  (See INSTALLATION )
  18. INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY  (See INSTALLATION )
  19. INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY  (See INSTALLATION )
  20. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH  (See INSTALLATION )
  21. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH  (See INSTALLATION )
  22. INSTALL NO. 1 ENGINE UNDER COVER  (See INSTALLATION )
  23. INSTALL ENGINE UNDER COVER ASSEMBLY  (See INSTALLATION )
About FixVault