Inspection Procedure

HINT:

After the inspection is completed, clear the DTCs (See DTC CHECK/CLEAR  ).

1. CHECK HARNESS AND CONNECTOR (MULTI-DISPLAY - TELEVISION CAMERA) 
   1. Disconnect the F27 display connector.
   2. Disconnect the S5 camera connector.
   3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance 

   RESISTANCE REFERENCE
   
   

   Tester Connection	Condition	Specified Condition
   S5-4 (CB+) - F27-13 (CA+)	Always	Below 1 Ω
   S5-3 (CGND) - F27-14 (CGND)	Always	Below 1 Ω
   S5-2 (CV+) - F27-27 (V+)	Always	Below 1 Ω
   S5-1 (CV-) - F27-28 (V-)	Always	Below 1 Ω
   S5-4 (CB+) - Body ground	Always	10 kΩ or higher
   S5-3 (CGND) - Body ground	Always	10 kΩ or higher
   S5-2 (CV+) - Body ground	Always	10 kΩ or higher
   S5-1 (CV-) - Body ground	Always	10 kΩ or higher

   NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

   Fig 1: Identifying F27 Display Connector & S5 Camera Connector

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   OK: Go to Next Step 

2. CHECK MULTI-DISPLAY (CA+ VOLTAGE) 
   1. Measure the voltage according to the value(s) in the table below.

      Standard Voltage 

   VOLTAGE SPECIFICATION
   
   

   Tester Connection	Condition	Specified Condition
   F27-13 (CA+) - F27-14 (CGND)	Engine switch on (IG), shift lever moved to R	5.8 to 6.5 V

   NG: REPLACE MULTI-DISPLAY  (See MULTI-DISPLAY (W/NAVIGATION SYSTEM)  )

   Fig 2: Identifying F27 Connector Terminal

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   OK: REPLACE TELEVISION CAMERA ASSEMBLY  (See REMOVAL )