Inspection Procedure

1. Enter the "Menu" screen by pressing the "MENU" switch.
2. Select "Setup".
   Fig 1: Display - Pressing Menu Switch

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Check that "Voice Recognition Guidance" is not OFF.

   OK: Voice Recognition Guidance is not OFF. 

NG: TURN VOICE RECOGNITION GUIDANCE "ON" 

Fig 2: Display - Voice Recognition Guidance

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

OK: Go to Next Step 

1. Check that the map disc is not deformed or cracked.

   OK: No deformations or cracks on map disc. 

NG: REPLACE MAP DISC 

Fig 3: Caution For Disc Cracks

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

OK: Go to Next Step 

1. Check for dirt on the map disc surface.

   OK: No dirt is on the map disc surface. 

   HINT:

   If the disc is dirty, clean the disc by wiping the disc surface radially with a soft cloth.

   NOTE: Do not use a conventional record cleaner or antistatic preservative.

   NG: CLEAN MAP DISC 

Fig 4: Cleaning Disc Surface In Radial Direction

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

OK: Go to Next Step 

1. Enter the "Mic & Voice Recognition Check" mode (See OPERATION CHECK  ).
2. When a voice is input into the microphone, check that the microphone input level meter changes according to the input voice.
3. Push the recording switch and perform voice recording.

   HINT:

   The recording limit is 5 seconds.

4. Check that the recording indicator remains on while recording and that the recorded voice is played normally without noise or distortion.

   OK: All check results are normal. 

NG: GO TO "MICROPHONE CIRCUIT BETWEEN OVERHEAD J/B AND MULTI-DISPLAY"  (See MICROPHONE CIRCUIT BETWEEN OVERHEAD J/B AND MULTI-DISPLAY  )

Fig 5: Display - Mic & Voice Recognition

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

OK: END