FixVault
Home › Toyota › 2009 › Land Cruiser › Repair and Diagnosis › Engine Performance › System › Engine Control System - Circuit Tests And Service Information › Power Steering Oil Pressure Switch › Removal

Power Steering Oil Pressure Switch: Removal

  1. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH  (See REMOVAL )
  2. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH  (See REMOVAL )
  3. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY  (See REMOVAL )
  4. REMOVE AIR CLEANER HOSE ASSEMBLY  (See REMOVAL )
  5. REMOVE AIR CLEANER ASSEMBLY  (See REMOVAL )
  6. REMOVE V-BANK COVER SUB-ASSEMBLY  (See REMOVAL )
  7. REMOVE FAN AND GENERATOR V BELT  (See REMOVAL )
  8. DRAIN POWER STEERING FLUID 
  9. REMOVE FRONT WHEEL 
  10. REMOVE FRONT FENDER APRON SEAL FRONT RH  (See REMOVAL )
  11. REMOVE POWER STEERING OIL PRESSURE SWITCH 
    1. Disconnect the switch connector.
    2. Using a 24 mm deep socket wrench, remove the oil pressure switch.
    3. Remove the O-ring.
      Fig 1: Locating Power Steering Oil Pressure Switch Connector
      G05628296Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
About FixVault