Tilt And Telescopic Manual Switch: Installation

INSTALL TILT AND TELESCOPIC MANUAL SWITCH
1. Attach the claw to install the switch.
2. Connect the switch connector.
  
  Fig 1: Locating Tilt And Telescopic Manual Switch Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL UPPER STEERING COLUMN COVER
1. Attach the claw.
2. Attach the 4 clips to install the upper steering column cover onto the instrument panel cluster finish panel.
  
  Fig 2: Installing Upper Steering Column Cover
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL LOWER STEERING COLUMN COVER
1. Attach the 2 claws to install the lower steering column cover.
  
  Fig 3: Identifying Claws On Lower Steering Column Cover
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the 3 screws.
  Torque: 1.5 N*m (15 kgf*cm, 13 in.*lbf)
  
  HINT:
  
  Turn the steering wheel to the right and left as necessary to install the 2 screws.
  
  Fig 4: Turning Steering Wheel
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: Reset the AUTO TILT AWAY function setting to the previous condition by changing the customize parameter (See CUSTOMIZE PARAMETERS ).
INSPECT SRS WARNING LIGHT
1. Inspect the SRS warning light (See DIAGNOSIS SYSTEM ).