FixVault
Home › Toyota › 2009 › Matrix Base, Standard › Repair and Diagnosis › Drivelines & Axles › Wheel Hubs › Axle & Differential › Steering Knuckle › Installation

Steering Knuckle: Installation

  1. INSTALL STEERING KNUCKLE 
    1. Using SST and a press, install a new front axle hub bearing to the steering knuckle.

      SST 09950-60020 (09951-00720), 09950-70010 (09951-07100) 

  2. INSTALL FRONT DISC BRAKE DUST COVER  (See INSTALLATION  )
  3. INSTALL FRONT AXLE HUB SUB-ASSEMBLY  (See INSTALLATION  )
  4. INSTALL FRONT AXLE HUB HOLE SNAP RING  (See INSTALLATION  )
    Fig 1: Installing Front Axle Hub Bearing Using SST
    G06034280Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. INSTALL FRONT LOWER BALL JOINT  (See INSTALLATION )
  6. INSTALL FRONT AXLE ASSEMBLY  (See INSTALLATION  )
  7. CONNECT FRONT LOWER SUSPENSION ARM  (See INSTALLATION )
  8. CONNECT TIE ROD END SUB-ASSEMBLY (for 2WD)  (See INSTALLATION )
  9. CONNECT TIE ROD END SUB-ASSEMBLY (for 4WD)  (See INSTALLATION )
  10. INSTALL FRONT DISC  (See INSTALLATION )
  11. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY  (See REPLACEMENT  )
  12. TEMPORARILY INSTALL FRONT AXLE SHAFT NUT  (See INSTALLATION  )
  13. SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY  (See REPLACEMENT  )
  14. REMOVE FRONT DISC  (See REMOVAL )
  15. INSPECT FRONT AXLE HUB BEARING LOOSENESS  (See ON-VEHICLE INSPECTION  )
  16. INSPECT FRONT AXLE HUB RUNOUT  (See ON-VEHICLE INSPECTION  )
  17. INSTALL FRONT DISC  (See INSTALLATION )
  18. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY  (See REPLACEMENT  )
  19. INSTALL FRONT SPEED SENSOR  (See INSTALLATION )
  20. INSTALL FRONT AXLE SHAFT NUT  (See INSTALLATION  )
  21. INSTALL FRONT WHEEL 

    Torque: 103 N*m (1050 kgf*cm, 76 ft.*lbf) 

  22. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT 

    HINT:

    (See FRONT WHEEL ALIGNMENT )

  23. CHECK FOR SPEED SENSOR SIGNAL (w/ VSC) 

    HINT:

    (See TEST MODE PROCEDURE )

  24. CHECK FOR SPEED SENSOR SIGNAL (w/ ABS) 

    HINT:

    (See TEST MODE PROCEDURE )

About FixVault