FixVault
Home › Toyota › 2009 › Matrix Base, Standard › Repair and Diagnosis › External Pages › Different variant/trim › Section 8 (Starting System (2AZ-FE)) › Relay › On-Vehicle Inspection

On-Vehicle Inspection

WARNING: This page is about a different variant/trim than selected.
  1. INSPECT STARTER RELAY 
    1. Check the resistance.
      1. Using an ohmmeter, measure the resistance between the terminals.

        Standard Resistance 

        Fig 1: Identifying Starter Relay Terminals With Circuit
        G06042958Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        RESISTANCE SPECIFIED CONDITION

        Tester Connection Condition Specified Condition
        3 - 5 Battery voltage is not applied to terminals 1 and 2. 10 kΩ or higher
        3 - 5 Battery voltage is applied to terminals 1 and 2. Below 1 Ω

        If the result is not as specified, replace the relay.

  2. INSPECT ACC RELAY 
    1. Check the resistance.
      1. Using an ohmmeter, measure the resistance between the terminals.

        Standard Resistance 

        RESISTANCE SPECIFIED CONDITION

        Tester Connection Condition Specified Condition
        3 - 5 Battery voltage is not applied to terminals 1 and 2. 10 kΩ or higher
        3 - 5 Battery voltage is applied to terminals 1 and 2. Below 1 Ω

        If the result is not as specified, replace the relay.

        Fig 2: Identifying ACC Relay Terminals With Circuit
        G04942983Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
About FixVault