FixVault
Home › Toyota › 2009 › Matrix Base, Standard › Repair and Diagnosis › Restraints › Air Bag, SRS › Supplemental Restraint System › Side Airbag Sensor › Installation

Side Airbag Sensor: Installation

  1. INSTALL SIDE AIRBAG SENSOR 
    1. Check that the ignition switch is off.
    2. Check that the cable is disconnected from the negative (-) battery terminal.
      CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
    3. Aligning the pin of the side airbag sensor to the body hole, install the side airbag sensor with the bolt.

      Torque: 9.0 N*m (92 kgf*cm, 80 in.*lbf) 

      Fig 1: Locating Side Airbag Sensor Bolt
      G06014932Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:
      • If the side airbag sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.
      • When installing the side airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.
      • Make sure that the pin is securely inserted into the body hole.
      • Tighten the bolt while holding the side airbag sensor because the side airbag sensor pin (stopper) is easily damaged.
    4. Connect the connector to the side airbag sensor.
      NOTE: When connecting the airbag connector, take care not to damage the airbag wire harness.
    5. Check that there is no looseness in the installation parts of the side airbag sensor.
  2. INSTALL LOWER CENTER PILLAR GARNISH  (See INSTALLATION )
  3. CONNECT FRONT SEAT OUTER BELT ASSEMBLY (for Driver Side)  (See INSTALLATION )
  4. INSTALL LAP BELT OUTER ANCHOR COVER (for Driver Side)  (See INSTALLATION )
  5. CONNECT FRONT SEAT OUTER BELT ASSEMBLY (for Front Passenger Side)  (See INSTALLATION )
  6. INSTALL LAP BELT OUTER ANCHOR COVER (for Front Passenger Side)  (See INSTALLATION )
  7. CONNECT REAR DOOR OPENING TRIM WEATHERSTRIP 

    for LH Side: (See INSTALLATION )

    for RH Side: (See INSTALLATION )

  8. INSTALL REAR DOOR SCUFF PLATE  (See INSTALLATION )
  9. CONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP 

    for LH Side: (See INSTALLATION )

    for RH Side: (See INSTALLATION )

  10. INSTALL FRONT DOOR SCUFF PLATE  (See INSTALLATION )
  11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  12. INSPECT SRS WARNING LIGHT 
    1. Inspect the SRS warning light (See DIAGNOSIS SYSTEM ).
About FixVault