FixVault
Home › Toyota › 2009 › Prius Base › Repair and Diagnosis › Hybrid/Electric Powertrain › Cooling Systems › P112 Hybrid Vehicle Control - Component And System Testing › Accelerator Pedal Rod › Installation

Accelerator Pedal Rod: Installation

  1. INSTALL ACCELERATOR PEDAL ROD 
    1. Install the accelerator pedal rod with the 2 bolts.

      Torque: 7.5 N*m (77 kgf*cm, 66 in.*lbf) 

    2. Connect the accelerator pedal position sensor connector.
      Fig 1: Installing Accelerator Pedal Rod
      G05674947Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL  (See INSTALLATION )
  3. INSTALL REAR NO. 3 FLOOR BOARD  (See INSTALLATION )
  4. INSTALL REAR DECK FLOOR BOX  (See INSTALLATION )
  5. INSTALL REAR NO. 2 FLOOR BOARD  (See INSTALLATION )
  6. PERFORM INITIALIZATION 
    1. Perform initialization (see INITIALIZATION ).
      CAUTION: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
About FixVault