Dome Fuse Installation During PDS (T-SB-0237-08)
Publication date: 2008-08-12Reference number: T-SB-0237-08
DOME FUSE INSTALLATION DURING PDS
TECHNICAL SERVICE BULLETIN
Reference Number(s): T-SB-0237-08, Date of Issue:
August 12, 2008
| TOYOTA: | 2009 Prius |
| Service Category: | General |
| SECTION: | Pre-Delivery Service |
| COPYRIGHT: | © 2018 Toyota, USA License Agreement TMS1002 |
Applicability
APPLICABILITY CHART
| YEAR(S) | MODEL(S) | ADDITIONAL INFORMATION |
|---|---|---|
| 2009 | Prius |
Introduction
To minimize battery discharge during transportation and storage, the DOME fuse has been removed at the assembly plant and temporarily stored in the blank space of the Relay Block in the engine compartment. Reinstall the DOME fuse into its original location and confirm all related DTCs are cleared during Pre-Delivery Service (PDS).
Required Tools & Equipment
REQUIRED TOOLS & EQUIPMENT
| REQUIRED EQUIPMENT | SUPPLIER | PART NUMBER | QTY | ||
|---|---|---|---|---|---|
| TIS Techstream(1)
NOTE:
Software version 3.01.000 or later is required.
|
ADE | TSPKG1 | 1 | ||
|
|||||
NOTE:
Additional TIS Techstream units may be ordered by calling Approved Dealer Equipment (ADE) at 1-800-368-6787.
Warranty Information
WARRANTY INFORMATION CHART
| OP CODE | DESCRIPTION | TIME | OFP | T1 | T2 |
|---|---|---|---|---|---|
| N/A | Not Applicable to Warranty | - | - | - | - |
Installation Procedure
Remove the DOME fuse (15A) from the blank space of the Relay Block in the engine compartment and install it in its original location during Pre-Delivery Service (PDS).
NOTE:
If the vehicle is stored in the dealership for a long period of time after PDS, disconnect the negative (-) battery terminal to prevent battery discharge. Refer to TSB No. T-SB-0235-08
, "MAINTENANCE FOR HV & AUXILIARY BATTERIES
".
DTC Clearing Procedure
With the DOME fuse removed, the occupant classification ECU and Center Airbag Sensor Assembly (airbag ECU) may detect the interruption in battery voltage (B+) and store a DTC. Clear DTCs B1650 and B1794 after installing the DOME fuse.
- Connect TIS Techstream to the DLC3.
- Turn the ignition switch to the "IG-ON" position.
- Using TIS Techstream, check any codes being output.NOTE: If any DTCs besides DTC B1650 and B1794 remain, repair the applicable system according to the Repair Manual.
- Erase DTCs (B1650 and B1794) and Freeze Frame Data.