Inspection Procedure

NOTE: When replacing the brake actuator assembly, perform zero point calibration (See CALIBRATION ).

CHECK CAN COMMUNICATION SYSTEM

Check if a CAN communication system DTC is output (See HOW TO PROCEED WITH TROUBLESHOOTING ).

Result

RESULT CHART

Result	Proceed to
DTC is not output.	A
DTC is output.	B

B : INSPECT CAN COMMUNICATION SYSTEM (See DIAGNOSTIC TROUBLE CODE CHART )

A : Go to Next Step

INSPECT COMBINATION METER ASSEMBLY
1. Inspect the combination meter (See HOW TO PROCEED WITH TROUBLESHOOTING ).
NG : REPLACE COMBINATION METER ASSEMBLY (See REMOVAL )

OK : REPLACE BRAKE ACTUATOR ASSEMBLY (See REMOVAL )