Fuel Pump: Inspection

INSPECT FUEL PUMP ASSEMBLY

Measure the resistance according to the value(s) in the table below.

Standard Resistance

TESTER CONNECTION SPECIFIED CONDITION CHART

Tester Connection	Condition	Specified Condition
1 - 2	20°C (68°F)	0.2 to 3.0 Ω

If the result is not as specified, replace the fuel pump assembly.

Fig 1: Identifying Fuel Pump Connector Terminals

G05998589

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Inspect the operation of the fuel pump.
1. Connect the positive (+) lead of the battery to terminal 1 of the connector, and the negative (-) lead to terminal 2. Check that the fuel pump operates.
  If the pump does not operate, replace the fuel pump assembly.
  NOTE:
  - This test must be performed within 10 seconds to prevent the coil from burning out.
  - Keep the fuel pump as far away from the battery as possible.
  - Always turn the voltage on and off on the battery side, not the fuel pump side.
    
    Fig 2: Connecting Positive (+) Lead Of Battery To Terminal 1 Of Connector, And Negative (-) Lead To Terminal 2
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002