Inspection Procedure

1. Disconnect the stereo component amplifier connectors.
Fig 1: Identifying Stereo Component Amplifier Connector Terminals
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Measure the resistance according to the values in the table below.

   Standard resistance 

   TESTER CONNECTION SPECIFIED CONDITION
   
   

   Tester connection	Condition	Specified condition
   GND - Body ground	Always	Below 1 Ω
   GND2 - Body ground	Always	Below 1 Ω

3. Measure the voltage according to the values in the table below.

   Standard voltage 

   TESTER CONNECTION SPECIFIED CONDITION
   
   

   Tester connection	Condition	Specified condition
   B+ - GND	Always	10 to 14 V
   B2+ - GND	Always	10 to 14 V
   ACC - GND	Ignition switch ACC	10 to 14 V

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE