FixVault
Home › Toyota › 2009 › Venza 2.7 E, AWD › Repair and Diagnosis › Engine Performance › System › Engine Control System (1AR-FE) - System Testing, Removal & Installation › Crankshaft Position Sensor › Removal

Crankshaft Position Sensor: Removal

  1. REMOVE FRONT FENDER APRON SEAL RH  (See REMOVAL )
  2. REMOVE CRANKSHAFT POSITION SENSOR 
    1. Disconnect the sensor connector.
    2. Remove the bolt and sensor.
      Fig 1: Locating Bolt And Sensor
      G05997198Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
About FixVault