Service Data
1AR-FE STARTING SERVICE DATA
| Starter assembly | Standard current: 90 A or less at 11.5 V | |
|---|---|---|
| Starter magnetic switch assembly | Standard resistance 50 - C: Below 1 Ω 50 - Body: Below 2 Ω |
|
| Starter armature assembly | Standard resistance Commutator: Below 1 Ω Commutator - Coil core: 10 kΩ or higher |
|
| Standard length: 3.1 to 3.8 mm (0.122 to 0.149 in.) | ||
| Starter commutator end frame | Standard length: 4.0 to 9.0 mm (0.158 to 0.354 in.) | |
| Standard resistance Positive (+) - Negative (-): 10 kΩ or higher |
||
| Snap ring | Maximum length: 5.0 mm (0.196 in.) | |
| Starter relay | 3-5:10 kΩ or higher 3-5: Below 1 Ω (when battery voltage is applied to terminals 1 and 2) |
|
| Engine switch | 7 (SS1) - 5 (GND) / 2 (SS2) - 5 (GND) Specified resistance Not pushed: 10 kΩ or higher Pushed: 15 Ω |
|
| Standard condition: Illuminates Measurement condition Battery positive 11 (SWIL) - Battery negative 4 (COM) or 5 (GND) Battery positive 12 (INDS) - Battery negative 4 (COM) or 5 (GND) Battery positive 13 (INDW) - Battery negative 4 (COM) or 5 (GND) |
||
| Ignition switch | Switch Position LOCK Between all terminals |
10 kΩ or higher |
| Switch Position ACC 2 (AM1)-3 (ACC) |
Below 1 Ω | |
| Switch Position ON 2 (AM1) - 3 (ACC) 2 (AM1) - 4 (IG1) 6 (IG2) - 7 (AM2) |
||
| Switch Position START 1 (ST1) - 2 (AM1) 2 (AM1) - 4 (IG1) 6 (IG2) - 7 (AM2) 7 (AM2) - 8 (ST2) |
||