FixVault
Home › Toyota › 2009 › Venza 2.7 E, AWD › Repair and Diagnosis › Transmission › Transfer Case › Transfer Assembly › Installation

Transfer Assembly: Installation

  1. INSTALL TRANSFER ASSEMBLY 
    1. Install the transfer assembly to the transaxle assembly with 2 new bolts and the 6 nuts.

      Torque: 69 N*m (700 kgf*cm, 51 ft.*lbf) 

      Fig 1: Identifying Transfer Assembly Bolts And Nuts
      G06025209Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    NOTE:
    • Install the transfer assembly to the transaxle assembly horizontally.
    • Do not touch the transfer assembly oil seals during installation.
  2. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY (for 2GR-FE)  (See INSTALLATION )
  3. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY (for 1AR-FE)  (See INSTALLATION )
  4. INSTALL FLEXIBLE HOSE BRACKET SUB-ASSEMBLY (for 2GR-FE)  (See INSTALLATION )
  5. INSTALL WIRE HARNESS (for 2GR-FE)  (See INSTALLATION )
  6. INSTALL WIRE HARNESS (for 1 AR-FE)  (See INSTALLATION )
  7. INSTALL TRANSFER STIFFENER PLATE RH (for 2GR-FE)  (See INSTALLATION )
  8. INSTALL TRANSFER STIFFENER PLATE RH (for 1AR-FE)  (See INSTALLATION )
  9. INSTALL MANIFOLD STAY (for 2GR-FE)  (See INSTALLATION )
  10. INSTALL STARTER ASSEMBLY (for 2GR-FE)  (See INSTALLATION )
  11. INSTALL STARTER ASSEMBLY (for 1AR-FE)  (See INSTALLATION )
  12. INSTALL FRONT FRAME ASSEMBLY (for 2GR-FE)  (See INSTALLATION )
  13. INSTALL FRONT FRAME ASSEMBLY (for 1AR-FE)  (See INSTALLATION )
  14. INSTALL REAR ENGINE MOUNTING INSULATOR ASSEMBLY (for 1AR-FE)  (See INSTALLATION )
  15. INSTALL STEERING LINK ASSEMBLY  (See INSTALLATION )
  16. INSTALL FRONT STABILIZER BAR WITH FRONT STABILIZER LINK ASSEMBLY 
  17. INSTALL FRONT NO. 1 STABILIZER BRACKET LH  (See INSTALLATION )
  18. INSTALL FRONT NO. 1 STABILIZER BRACKET RH 

    HINT:

    Perform the same procedure as for the LH side.

  19. INSTALL ENGINE ASSEMBLY WITH TRANSAXLE 

    See INSTALLATION for 2GR-FE

    See INSTALLATION for 1AR-FE

About FixVault