Acc Cut Relay: Inspection

INSPECT ACC CUT RELAY

Check the resistance.

Using an ohmmeter, measure the resistance between the terminals. Standard resistance

ACC CUT RELAY

Tester Connection	Specified Condition
3-4	Below 1 ohm
3-4	10 k ohms or higher (when battery voltage applied to terminals 1 and 2)
3-5	Below 1 ohm (when battery voltage applied to terminals 1 and 2)
3-5	10 k ohms or higher

If the result is not as specified, replace the relay.

Fig 1: Measuring Resistance Between ACC Cut Relay Terminals