Rear Combination Light Assembly: Removal

WARNING: This page is about a different car, the 2009 Toyota Prius. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

Use the same procedures for the RH and LH sides.
The procedures listed below are for the LH side.

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
REMOVE REAR COMBINATION LIGHT SERVICE COVER LH
REMOVE REAR COMBINATION LIGHT ASSEMBLY LH
1. Remove the 2 nuts.
2. Slide the 2 pins towards the back of the vehicle to remove them.
3. Disconnect the connector and remove the rear combination light.
4. Remove the 3 bulb sockets and 3 bulbs from the rear combination light.
  
  Fig 1: Removing Rear Combination Light Assembly LH
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002