Rear Speed Sensor: Installation: Installation

1. Clean the contact surface of the axle hub and a new skid control sensor.
   Fig 1: Identifying Contact Surface Of Axle Hub And Skid Control Sensor

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   NOTE:

   Prevent foreign matter from attaching to the sensor rotor.

2. Place the skid control sensor on the axle hub so that the connector is positioned as shown in the illustration.
3. Using SST and a press, install the skid control sensor to the axle hub.
   Fig 2: Installing Skid Control Sensor To Axle Hub

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   • SST: 09830-36010 
   • SST: 09950-60010 
     • 09951-00650
   • SST: 09950-70010 
     • 09951-07100
   NOTE:

   • Do not tap the skid control sensor with a hammer directly.
   • Check that there should be no foreign matter on the skid control sensor detection portion.
   • Press the skid control sensor in the axle hub straight and slowly.

1. Install the rear axle hub & bearing assembly with the 4 bolts.
   Fig 3: Locating Rear Axle Hub Bolts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Torque: 80 N*m (816 kgf*cm, 59 ft.*lbf) 

1. Connect the connector to the skid control sensor.
   Fig 4: Locating Skid Control Sensor Connector

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf) 

1. Check for speed sensor signal. Refer to TEST MODE PROCEDURE .