FixVault
Home › Toyota › 2010 › FJ Cruiser RWD › Repair and Diagnosis (Single Page) › Brakes › Traction Control › Brake Control System (Service Information) › Steering Angle Sensor › Installation › Installation

Steering Angle Sensor: Installation: Installation

  1. PRECAUTION 

    Refer toPRECAUTION

  2. INSTALL STEERING ANGLE SENSOR 
    Fig 1: Identifying Steering Angle Sensor & Claw
    GTY180555Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Install the steering angle sensor.
    2. Connect the harness and steering angle sensor connector.
      Fig 2: Identifying Steering Angle Sensor Connector, Harness & Claw
      GTY201913Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Connect the steering sensor connector.
  3. INSTALL SPIRAL CABLE  . Refer toINSTALLATION - Step 2
  4. INSTALL UPPER STEERING COLUMN COVER  . Refer toINSTALLATION - Step 16
  5. INSTALL LOWER STEERING COLUMN COVER  . Refer toINSTALLATION - Step 17
  6. ADJUST SPIRAL CABLE  . Refer toINSTALLATION - Step 5
  7. INSTALL STEERING WHEEL ASSEMBLY  . Refer toINSTALLATION - Step 18
  8. INSPECT STEERING WHEEL CENTER POINT 
  9. INSTALL STEERING PAD  . Refer toINSTALLATION - Step 2
  10. INSTALL STEERING WHEEL COVER LOWER NO. 2  . Refer toINSTALLATION - Step 4
  11. INSTALL STEERING WHEEL COVER LOWER NO. 3  . Refer toINSTALLATION - Step 3
  12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 

    Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf) 

  13. INSPECT STEERING PAD  . Refer toINSTALLATION - Step 6
  14. PERFORM INITIALIZATION 

    Refer toINITIALIZATION

  15. INSPECT SRS WARNING LIGHT 

    Refer toDIAGNOSIS SYSTEM

About FixVault