FixVault
Home › Toyota › 2010 › FJ Cruiser RWD › Repair and Diagnosis › Brakes › Traction Control › Brake Control System (Service Information) › Steering Angle Sensor › Removal › Removal

Steering Angle Sensor: Removal: Removal

  1. PRECAUTION 

    Refer toPRECAUTION

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
  3. PLACE FRONT WHEELS FACING STRAIGHT AHEAD 
  4. REMOVE STEERING WHEEL COVER LOWER NO. 3  . Refer toREMOVAL - Step 3
  5. REMOVE STEERING WHEEL COVER LOWER NO. 2  . Refer toREMOVAL - Step 4
  6. REMOVE STEERING PAD  . Refer toREMOVAL - Step 5
  7. REMOVE STEERING WHEEL ASSEMBLY  . Refer toREMOVAL - Step 7
  8. REMOVE LOWER STEERING COLUMN COVER  . Refer toREMOVAL - Step 8
  9. REMOVE UPPER STEERING COLUMN COVER  . Refer toREMOVAL - Step 9
  10. REMOVE SPIRAL CABLE  . Refer toREMOVAL - Step 10
  11. REMOVE STEERING ANGLE SENSOR 
    1. Disconnect the steering angle sensor connector.
    2. Disengage the claw and disconnect the steering angle sensor connector and harness.
      Fig 1: Identifying Steering Angle Sensor Connector, Harness & Claw
      GTY201913Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Disengage the 2 claws and remove the steering angle sensor.
      Fig 2: Identifying Steering Angle Sensor & Claw
      GTY180555Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
About FixVault