FixVault
Home › Toyota › 2010 › Highlander Hybrid › Repair and Diagnosis › Engine Performance › Engine Control Systems › Engine Control System (3MZ-FE) (Service Information) (Hybrid) › VVT Sensor › Removal › Removal

VVT Sensor: Removal: Removal

  1. REMOVE COOL AIR INTAKE DUCT SEAL  . Refer to REMOVAL - Step 11
  2. REMOVE NO. 2 ENGINE ROOM SIDE COVER LH  . Refer to REMOVAL - Step 10
  3. REMOVE AIR CLEANER CAP SUB-ASSEMBLY  . Refer to REMOVAL - Step 9
  4. REMOVE VVT SENSOR (for Bank 1) 
    1. Disconnect the VVT sensor connector.
      Fig 1: Identifying VVT Sensor And Bolt
      GTY181020Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the bolt, and then remove the VVT sensor.
  5. REMOVE VVT SENSOR (for Bank 2) 
    1. Disconnect the heated oxygen sensor connector (Bank 2) from the wire harness bracket.
      Fig 2: Locating Heated Oxygen Sensor Connector (For Bank 2)
      GTY191869Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disconnect the VVT sensor connector.
      Fig 3: Locating VVT Sensor Bolt And Connector (For Bank 2)
      GTY168598Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the bolt, and then remove the VVT sensor.
About FixVault