FixVault
Home › Toyota › 2010 › Highlander Limited, AWD › Repair and Diagnosis › Engine Performance › Engine Control Systems › Engine Control System (2GR-FE) (Service Information) (Except Hybrid) › Throttle Body › Installation › Installation

Throttle Body: Installation: Installation

  1. INSTALL THROTTLE BODY 
    1. Install a new throttle body gasket to the intake air surge tank.
      Fig 1: Identifying Recess
      GTY183812Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Install the throttle body with the 4 bolts.
      Fig 2: Locating Bolts On Throttle Body
      GTY131385Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf) 

    3. Connect the 2 water by-pass hoses.
      Fig 3: Identifying Water By-Pass Hoses
      GTY142859Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Connect the throttle body connector and clamp.
      Fig 4: Locating Throttle Body Connector & Clamp
      GTY146907Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL AIR CLEANER CAP SUB-ASSEMBLY  . Refer to INSTALLATION - Step 5
  3. ADD ENGINE COOLANT  . Refer to REPLACEMENT - Step 5
  4. INSPECT FOR COOLANT LEAK  . Refer to ON-VEHICLE INSPECTION - Step 1
  5. INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY  . Refer to INSTALLATION - Step 12
  6. INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY  . Refer to INSTALLATION - Step 2
  7. INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY  . Refer to INSTALLATION - Step 3
  8. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH  . Refer to INSTALLATION - Step 5
  9. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH  . Refer to INSTALLATION - Step 6
  10. INSTALL V-BANK COVER SUB-ASSEMBLY  . Refer to INSTALLATION - Step 102
  11. INSTALL NO. 1 ENGINE UNDER COVER  . Refer to INSTALLATION - Step 100
  12. INSTALL ENGINE UNDER COVER ASSEMBLY  . Refer to INSTALLATION - Step 101
About FixVault