FixVault
Home › Toyota › 2010 › Land Cruiser › Repair and Diagnosis › Transmission › Transfer Case › Transfer Case (Service Information) › 4WD Control Ecu › Installation › Installation

4WD Control Ecu: Installation: Installation

  1. INSTALL 4WD CONTROL ECU 
    1. Install the ECU with the bolt.

      Torque: 13 N*m (127 kgf*cm, 9 ft.*lbf) 

      Fig 1: Identifying ECU Connector With Bolt
      GTY219340Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Connect the 2 ECU connectors.
  2. INSTALL LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL  . Refer to INSTALLATION - Step 21
  3. INSTALL INSTRUMENT PANEL BOX DOOR KNOB  . Refer to INSTALLATION - Step 22
  4. INSTALL NO. 3 INSTRUMENT CLUSTER FINISH PANEL GARNISH  . Refer to INSTALLATION - Step 23
  5. INSTALL FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY  . Refer to INSTALLATION - Step 1
  6. INSTALL COWL SIDE TRIM BOARD RH  . Refer to INSTALLATION - Step 25
  7. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY  . Refer to INSTALLATION - Step 26
  8. INSTALL FRONT DOOR SCUFF PLATE RH  . Refer to INSTALLATION - Step 76
  9. INSTALL LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH  . Refer to INSTALLATION - Step 50
  10. INSTALL NO. 1 INSTRUMENT PANEL FINISH CUSHION  . Refer to INSTALLATION - Step 51
About FixVault