FixVault
Home › Toyota › 2010 › Matrix Base, Automatic › Repair and Diagnosis › External Pages › Different variant/trim › Section 23 (Engine Control System (2AZ-FE) (Service Information)) › Engine Coolant Temperature Sensor › Installation › Installation

Engine Coolant Temperature Sensor: Installation: Installation

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL ENGINE COOLANT TEMPERATURE SENSOR 
    1. Install the engine coolant temperature sensor through a new gasket.
      Fig 1: Identifying Engine Coolant Temperature Sensor And Gasket
      GTY194547Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Torque: 20 N*m (204 kgf*cm, 15 ft.*lbf) 

    2. Connect the engine coolant temperature sensor connector.
      Fig 2: Locating Engine Coolant Temperature Sensor Connector
      GTY194546Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL AIR CLEANER CASE  . Refer to INSTALLATION - Step 64
  3. INSTALL AIR CLEANER CAP SUB-ASSEMBLY WITH HOSE  See step  2
  4. ADD ENGINE COOLANT  . Refer to REPLACEMENT - Step 2
  5. INSPECT FOR COOLANT LEAK  . Refer to ON-VEHICLE INSPECTION - Step 1
  6. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY  . Refer to INSTALLATION - Step 93
About FixVault