FixVault
Home › Toyota › 2010 › Matrix S, FWD, Automatic › Repair and Diagnosis (Single Page) › Accessories & Equipment › Cruise Control Systems › Cruise Control System (Diagnostics - Introduction) › Cruise Control System › DTC Check/Clear › DTC Check/Clear

DTC Check/Clear

  1. CHECK DTC 
    1. Connect the Techstream to the DLC3.
    2. Turn the ignition switch to ON.
    3. Turn the Techstream on.
    4. Enter the following menus: Powertrain/Cruise Control/Trouble Codes.
    5. Check the details of the DTC(s) . Refer to DIAGNOSTIC TROUBLE CODE CHART .
  2. CLEAR DTC 
    1. Connect the Techstream to the DLC3.
    2. Turn the ignition switch to ON.
    3. Turn the Techstream on.
    4. Enter the following menus: Powertrain/Cruise Control/Trouble Codes.
    5. Clear the DTCs.
About FixVault