FixVault
Home › Toyota › 2010 › RAV4 Base, 2.5 F, FWD › Repair and Diagnosis › Engine Performance › Engine Control Systems › Engine Control System (2AR-FE) (Service Information) › Accelerator Pedal Rod › On-Vehicle Inspection › On-Vehicle Inspection

On-Vehicle Inspection

  1. INSPECT ACCELERATOR PEDAL SENSOR ASSEMBLY 
    1. Connect the Techstream to the DLC3.
    2. Turn the ignition switch to ON.
    3. Turn the Techstream on.
    4. Enter the following menus: Powertrain / Engine and ECT / Data List / ETCS / Accel Sensor Out No. 1 and Accel Sensor Out No. 2.
    5. Read the value displayed on the Techstream.

      Standard Voltage

      Accel Sensor Out No. 1

      Condition Specified Condition
      Accelerator pedal is released 0.5 to 1.1 V
      Accelerator pedal is depressed 2.6 to 4.5 V

      Standard Voltage

      Accel Sensor Out No. 2

      Condition Specified Condition
      Accelerator pedal is released 1.2 to 2.0 V
      Accelerator pedal is depressed 3.4 to 5.0 V

      If the result is not as specified, check the accelerator pedal sensor assembly, wire harness and ECM.

About FixVault