How To Proceed With Troubleshooting

HINT: 

• Use these procedures to troubleshoot the vehicle stability control system.
• *: Use the Techstream.

1. VEHICLE BROUGHT TO WORKSHOP 

   NEXT: Go to next step 

2. INSPECT BATTERY VOLTAGE 

   Standard voltage

   11 to 14 V

   If the voltage is below 11 V, recharge or replace the battery before proceeding.

   NEXT: Go to next step 

3. CHECK AND CLEAR DTC* 

   NEXT: Go to next step 

4. PROBLEM SYMPTOM CONFIRMATION 

   Result

   Result	Proceed to
   Symptom does not occur	A
   Symptom occurs	B

   B → Go to step   7 

   A: Go to next step 

5. SYMPTOM SIMULATION 

   NEXT: Go to next step 

6. CHECK COMMUNICATION FUNCTION OF CONTROLLER AREA NETWORK (CAN)* 
   1. Using the Techstream, check for normal functioning of the CAN communication system.
      1. Perform bus check (communication malfunction DTC).

      Result

      Result	Proceed to
      DTC is not output	A
      DTC is output	B

      B → Go to  CAN COMMUNICATION SYSTEM 

      A: Go to next step 

7. CHECK FOR DTC* 

   Result

   Result	Proceed to
   DTC is not output	A
   DTC is output	B

   B → Go to step  10 

   A: Go to next step 

8. PROBLEM SYMPTOMS TABLE 

   Result

   Result	Proceed to
   Fault is not listed in problem symptoms table	A
   Fault is listed in problem symptoms table	B

   B → Go to step   10 

   A: Go to next step 

9. OVERALL ANALYSIS AND TROUBLESHOOTING 
   1. Refer to TERMINALS OF ECU 
   2. Data List/Active Test. Refer to DATA LIST / ACTIVE TEST 

      NEXT → Go to step   11 

10. CHECK FOR FLUID LEAKAGE 

    NEXT: Go to next step 

11. REPAIR OR REPLACE 

    NEXT: Go to next step 

12. CONFIRMATION TEST 

    NEXT → END