DTC B2313: Glass Position Initialization Incomplete: Procedure

1. Turn the ignition switch to ON.
2. Initialize the power window regulator motor assembly. Refer to INITIALIZATION .

   HINT: 

   Initialize the power window regulator motor assembly that has DTC B2313 stored in its ECU.

NEXT: Go to next step 

1. Turn the ignition switch off.
2. Wait for at least 10 seconds, and then turn the ignition switch to ON.
3. Check for DTCs. Refer to DTC CHECK / CLEAR .

   HINT: 

   Check for DTCs for the power window regulator motor assembly that has DTC B2313 stored in its ECU.

   OK

   B2313 output does not recur.

   Result

   Result	Proceed to
   OK	A
   NG (Driver side power window)	B
   NG (Front passenger side power window)	C
   NG (Rear LH side power window)	D
   NG (Rear RH side power window)	E

B → See step   3 

C → See step   4 

D → See step   5 

E → See step   6 

A → END (POWER WINDOW CONTROL SYSTEM HAS NOT BEEN INITIALIZED)