FixVault
Home › Toyota › 2011 › Tacoma X-Runner › Repair and Diagnosis › Brakes › Traction Control › Brake Control System (Service Information) › Steering Angle Sensor › Installation (To 12/2010) › Installation

Installation (To 12/2010): Installation

  1. INSTALL STEERING SENSOR 
    Fig 1: Locating Steering Sensor At Spiral Cable Claw
    GTY209069Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Install the steering sensor onto the spiral cable.
      NOTE:
      • Engage the claws securely.
      • Be careful not to damage the claws.
  2. REMOVE PLACE FRONT WHEELS FACING STRAIGHT AHEAD 
  3. INSTALL SPIRAL CABLE  . Refer to INSTALLATION - Step 2
  4. CENTER SPIRAL CABLE  . Refer to INSTALLATION - Step 3
  5. INSTALL STEERING COLUMN COVER UPPER  . Refer to INSTALLATION - Step 4
  6. INSTALL STEERING COLUMN COVER LOWER  . Refer to INSTALLATION - Step 5
  7. INSTALL STEERING WHEEL ASSEMBLY  . Refer to INSTALLATION - Step 21
  8. INSTALL STEERING PAD ASSEMBLY  . Refer to INSTALLATION - Step 1
  9. INSTALL STEERING WHEEL COVER LOWER NO. 3  . Refer to INSTALLATION - Step 23
  10. INSTALL STEERING WHEEL COVER LOWER NO. 2  . Refer to INSTALLATION - Step 24
  11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 

    Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf) 

  12. INSPECT STEERING PAD ASSEMBLY 
  13. INSPECT SRS WARNING LIGHT 

    Refer to DIAGNOSIS SYSTEM

About FixVault