FixVault
Home › Toyota › 2011 › Tundra Base, 4.0 U › Repair and Diagnosis › Brakes › Traction Control › Brake Control System (Service Information) › Steering Angle Sensor › Removal › Removal

Steering Angle Sensor: Removal: Removal

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    WARNING:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

  2. PLACE FRONT WHEELS FACING STRAIGHT AHEAD 
  3. REMOVE LOWER NO. 3 STEERING WHEEL COVER  . Refer to REMOVAL - Step 2
  4. REMOVE LOWER NO. 2 STEERING WHEEL COVER  . Refer to REMOVAL - Step 3
  5. REMOVE STEERING PAD  . Refer to REMOVAL - Step 4
  6. REMOVE STEERING WHEEL ASSEMBLY  . Refer to REMOVAL - Step 7
  7. REMOVE LOWER STEERING COLUMN COVER  . Refer to REMOVAL - Step 8
  8. REMOVE UPPER STEERING COLUMN COVER  . Refer to REMOVAL - Step 9
  9. REMOVE SPIRAL CABLE SUB-ASSEMBLY  . Refer to REMOVAL - Step 9
  10. REMOVE STEERING ANGLE SENSOR  . Refer to REMOVAL - Step 9
About FixVault