FixVault
Home › Toyota › 2012 › FJ Cruiser 4WD, Automatic T/Case Control › Repair and Diagnosis › External Pages › Different car › Section 50 (Engine Control System (Service Information)) › Engine Coolant Temperature Sensor › Installation › Installation

Engine Coolant Temperature Sensor: Installation: Installation

WARNING: This page is about a different car, the 2012 Lexus GX 460. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL ENGINE COOLANT TEMPERATURE SENSOR 
    1. Install a new gasket to the engine coolant temperature sensor.
    2. Install the engine coolant temperature sensor.

      Torque: 20 N*m (200 kgf*cm, 14 ft.*lbf) 

    3. Connect the engine coolant temperature sensor connector.
  2. ADD ENGINE COOLANT  . Refer to REPLACEMENT - Step 6
  3. INSPECT FOR COOLANT LEAK  . Refer to ON-VEHICLE INSPECTION - Step 1
  4. INSTALL V-BANK COVER SUB-ASSEMBLY  . Refer to INSTALLATION - Step 80
  5. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY  . Refer to INSTALLATION - Step 88
  6. INSTALL LOWER FRONT BUMPER COVER  . Refer to INSTALLATION - Step 89
About FixVault