FixVault
Home › Toyota › 2012 › FJ Cruiser 4WD, Automatic T/Case Control › Repair and Diagnosis › Restraints › Restraints Control Systems › Supplemental Restraint System (Service Information) › Center Airbag Sensor Assembly › Removal › Removal

Center Airbag Sensor Assembly: Removal: Removal

  1. PRECAUTION 
    WARNING:

    Read "PRECAUTION" thoroughly before servicing. Refer to PRECAUTION .

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    WARNING:

    Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working.

  3. REMOVE INSTRUMENT PANEL GARNISH LH  . Refer to REMOVAL - Step 15
  4. REMOVE INSTRUMENT PANEL GARNISH RH  . Refer to REMOVAL - Step 16
  5. REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY  . Refer to REMOVAL - Step 17
  6. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle)  . Refer to REMOVAL - Step 20
  7. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for 4WD)  . Refer to REMOVAL - Step 21
  8. REMOVE PARKING BRAKE HOLE COVER SUB-ASSEMBLY  . Refer to REMOVAL - Step 19
  9. REMOVE CONSOLE UPPER REAR PANEL SUB-ASSEMBLY  . Refer to REMOVAL - Step 22
  10. REMOVE BOX BOTTOM MAT  . Refer to REMOVAL - Step 23
  11. REMOVE FRONT CONSOLE BOX  . Refer to REMOVAL - Step 24
  12. REMOVE CONSOLE UPPER PANEL NO. 1 GARNISH  . Refer to REMOVAL - Step 25
  13. REMOVE INSTRUMENT LOWER COVER SUB-ASSEMBLY  . Refer to REMOVAL - Step 26
  14. REMOVE CENTER AIRBAG SENSOR ASSEMBLY 
    1. Disconnect the holder (with connectors) from the center airbag sensor assembly.
      Fig 1: Identifying Holder
      GTY201539Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove 3 bolts and the center airbag sensor assembly.
      Fig 2: Identifying Center Airbag Sensor Assembly Bolts
      GTY201544Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
About FixVault