FixVault
Home › Toyota › 2012 › Matrix S, FWD, Standard Trans › Repair and Diagnosis › External Pages › Different car › Section 210 (Cruise Control System (Service Information)) › Cruise Control Main Switch › Installation › Installation

Cruise Control Main Switch: Installation: Installation

WARNING: This page is about a different car, the 2011 Toyota Matrix. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL CRUISE CONTROL MAIN SWITCH 
    1. Engage the pin and install the cruise control main switch as shown in the illustration.
      Fig 1: Installing Cruise Control Main Switch
      GTY247032Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Connect the connector.
    3. Install the 2 screws.
      Fig 2: Remove/Install Cruise Control Main Switch Screws
      GTY247033Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL STEERING PAD  . Refer to INSTALLATION - Step 1
  3. INSTALL LOWER NO. 3 STEERING WHEEL COVER  . Refer to INSTALLATION - Step 2
  4. INSTALL LOWER NO. 2 STEERING WHEEL COVER  . Refer to INSTALLATION - Step 3
  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  6. INSPECT STEERING PAD  . Refer to INSTALLATION - Step 5
  7. INSPECT SRS WARNING LIGHT 
    1. Inspect the SRS warning light. Refer to DIAGNOSIS SYSTEM .
About FixVault