Steering Wheel: Installation: Installation

INSTALL STEERING WHEEL BOSS LOWER COVER
1. Attach the 4 claws and 2 screws and install the steering wheel boss lower cover.
  
  Fig 1: 4 Claws And 2 Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL STEERING SHAKE DAMPER
1. Install the 2 screws to steering shake damper.
  
  Fig 2: 2 Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL STEERING WHEEL HEATER CONTROL ASSEMBLY (w/ Steering Heater) See step 1
ADJUST SPIRAL CABLE . Refer to INSTALLATION - Step 4
INSTALL STEERING WHEEL ASSEMBLY
1. Align the matchmarks on the steering wheel assembly and steering main shaft assembly.
  
  Fig 3: Align The Matchmarks
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  TEXT IN ILLUSTRATION
  
  *a Matchmark
2. Install the steering wheel assembly set nut.
  Torque: 50 N*m (510 kgf*cm, 37 ft.*lbf)
INSTALL CRUISE CONTROL MAIN SWITCH . Refer to INSTALLATION - Step 1
INSTALL STEERING PAD SWITCH ASSEMBLY
1. Attach the 4 claws to install the steering pad switch.
  
  Fig 4: Locating Steering Pad Switch Assembly Connectors, Screws And Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the 2 screws.
3. Connect the connector.
INSTALL STEERING PAD . Refer to INSTALLATION - Step 1
INSTALL LOWER NO. 2 STEERING WHEEL COVER . Refer to INSTALLATION - Step 3
INSTALL LOWER NO. 3 STEERING WHEEL COVER . Refer to INSTALLATION - Step 2
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION .
CHECK SRS WARNING LIGHT
Refer to DIAGNOSIS SYSTEM