Shift Lever: Installation: Installation

INSTALL SHIFT LOCK CONTROL UNIT ASSEMBLY
1. Install the shift lock control unit assembly with the 3 nuts.
  
  Fig 1: Identifying Shift Lock Control Unit Assembly, Connector & Nuts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  Torque: 12 N*m (122 kgf*cm, 9 ft.*lbf)
2. Connect the connector to the shift lock control unit assembly.
INSTALL LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY . Refer to INSTALLATION - Step 30
INSTALL INTEGRATION CONTROL AND PANEL ASSEMBLY . Refer to INSTALLATION - Step 31
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION .
INSTALL REAR NO. 3 FLOOR BOARD . Refer to INSTALLATION - Step 58
INSTALL REAR DECK FLOOR BOX . Refer to INSTALLATION - Step 59
INSTALL REAR NO. 2 FLOOR BOARD (for Separate Type) . Refer to INSTALLATION - Step 60
INSPECT SHIFT LEVER
1. Turn the power switch on (IG).
2. Check that all available shift positions can be selected moving the shift lever.
  HINT:
  
  After the shift lever is replaced with a new one, perform the above operation. If this operation is not performed, moving the shift lever may not initially select shift positions.