FixVault
Home › Toyota › 2013 › Prius V › Repair and Diagnosis › Engine Mechanical › Starter › Smart Key System (For Start Function) (Diagnostic Codes & Symptom Tests) › Smart Key System (For Start Function) › Symptom Tests › Power Source Mode does not Change to ON (ACC) › Procedure

Power Source Mode does not Change to ON (ACC): Procedure

  1. CHECK HARNESS AND CONNECTOR (AUXILIARY BATTERY - POWER MANAGEMENT CONTROL ECU) See step   1 

    NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

    OK: Go to next step 

  2. CHECK HARNESS AND CONNECTOR (POWER MANAGEMENT CONTROL ECU - BODY GROUND) See step   2 

    NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

    OK: Go to next step 

  3. INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY See step   3 

    NG → See step   7 

    OK: Go to next step 

  4. CHECK HARNESS AND CONNECTOR (POWER MANAGEMENT CONTROL ECU - INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY) See step   4 

    NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

    OK: Go to next step 

  5. CHECK HARNESS AND CONNECTOR (INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY - BODY GROUND) See step   5 

    NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

    OK: Go to next step 

  6. INSPECT POWER MANAGEMENT CONTROL ECU See step   6 

    NG → See step   8 

    OK → See step   9 

  7. REPLACE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY. Refer to  REMOVAL 
  8. REPLACE POWER MANAGEMENT CONTROL ECU. Refer to  REMOVAL 
  9. USE SIMULATION METHOD TO CHECK. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING 
About FixVault