Power Vent Window Motor Circuit: Procedure

1. Disconnect the power quarter window switch connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   D3-5 (E) - Body ground	Always	Below 1 Ω

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: Go to next step 

1. Measure the voltage according to the value(s) in the table below.
   Fig 1: Checking Harness And Connector (Battery - Power Quarter Window Switch)

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Standard Voltage

   Tester Connection	Switch Condition	Specified Condition
   D3-1 (B) - D3-5 (E)	Ignition switch ON	11 to 14 V
   D3-1 (B) - D3-5 (E)	Ignition switch off	Below 1 V

   TEXT IN ILLUSTRATION
   
   

   *a	Front view of wire harness connector (to Power Quarter Window Switch)

NG → CHECK FOR ALL HARNESSES, CONNECTORS AND COMPONENTS CONNECTED TO P/VENT FUSE 

OK: Go to next step 

1. Remove the power quarter window switch.
   Fig 2: Inspecting Power Quarter Window Switch

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Switch Condition	Specified Condition
   D3-1 (B) - D3-3 (OPEN)	Open position → Close position	Below 1 Ω → 10 kΩ or higher
   D3-1 (B) - D3-4 (CLS)	Open position → Close position	10 kΩ or higher → Below 1 Ω
   D3-3 (OPEN) - D3-5 (E)	Open position → Close position	10 kΩ or higher → Below 1 Ω
   D3-4 (CLS) - D3-5 (E)	Open position → Close position	Below 1 Ω → 10 kΩ or higher

   TEXT IN ILLUSTRATION
   
   

   *a	Component without harness connected (Power Quarter Window Switch)

NG → REPLACE POWER QUARTER WINDOW SWITCH 

OK: Go to next step 

1. Disconnect the power vent window motor assembly LH and RH connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   D3-3 (OPEN) - K15-1 (OPEN)	Always	Below 1 Ω
   D3-4 (CLS) - K15-2 (CLS)	Always	Below 1 Ω
   D3-3 (OPEN) - L28-1 (OPEN)	Always	Below 1 Ω
   D3-4 (CLS) - L28-2 (CLS)	Always	Below 1 Ω
   D3-3 (OPEN) - Body ground	Always	10 kΩ or higher
   D3-4 (CLS) - Body ground	Always	10 kΩ or higher

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: Go to next step 

1. Check the operation of the rear quarter power window control system.

   Result

   Result	Proceed to
   The rear quarter power window control system operates normally.	A
   The power vent window motor assembly LH does not operate normally.	B
   The power vent window motor assembly RH does not operate normally.	C

B → See step   6 

C → See step   8 

A → See step   7