Rear Speed Sensor: Installation: Installation

INSTALL REAR SPEED SENSOR

Fig 1: Installing Rear Speed Sensor
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1. Install the rear speed sensor with the nut.
  Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)
  
  NOTE:
  Make sure that the sensor tip is clean.
2. Connect the speed sensor connector.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
CHECK VSC SENSOR SIGNAL (for Hydraulic Brake Booster)
Refer to TEST MODE PROCEDURE
CHECK VSC SENSOR SIGNAL (for Vacuum Brake Booster)
Refer to TEST MODE PROCEDURE