FixVault
Home › Toyota › 2016 › Prius C Two › Repair and Diagnosis › Brakes › Traction Control › Brake Control System (Service Information) › Steering Angle Sensor › Removal [11/2015 - ] › Procedure

Removal [11/2015 - ]: Procedure

  1. REMOVE STEERING WHEEL ASSEMBLY 

    (Refer to REMOVAL [11/2015 - 06/2017] , or refer to REMOVAL [06/2017 - ] )

  2. REMOVE LOWER STEERING COLUMN COVER 

    Refer to PROCEDURE - Step 5

  3. REMOVE UPPER STEERING COLUMN COVER 

    Refer to PROCEDURE - Step 6

  4. REMOVE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY 
    1. Remove the spiral cable with sensor sub-assembly (Refer to PROCEDURE - Step 4 ).
      NOTE:
      • Do not replace the spiral cable with sensor sub-assembly with the auxiliary battery connected and the ignition switch ON.
      • Do not rotate the spiral cable with sensor sub-assembly without the steering wheel with the auxiliary battery connected and the ignition switch ON.
      • Ensure that the steering wheel is installed and aligned straight when inspecting the steering angle sensor.
      • Do not remove the steering angle sensor from the spiral cable.
About FixVault