On-Vehicle Inspection [12/2015 - 08/2016]: Procedure

INSPECT ACCELERATOR PEDAL SENSOR ASSEMBLY

Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / Engine / Data List / Accel Sensor Out No. 1 and Accel Sensor Out No. 2.

Read the values displayed on the Techstream.

Standard Voltage

Tester Display	Condition	Specified Condition
Accel Sensor Out No. 1	Accelerator pedal is released	0.5 to 1.1 V
Accel Sensor Out No. 1	Accelerator pedal is fully depressed	2.6 to 4.5 V
Accel Sensor Out No. 2	Accelerator pedal is released	1.2 to 2.0 V
Accel Sensor Out No. 2	Accelerator pedal is fully depressed	3.4 to 4.8 V

If the result is not as specified, check the accelerator pedal sensor assembly, wire harness or ECM.