FixVault
Home › Toyota › 2017 › 4Runner TRD Pro › Repair and Diagnosis › Brakes › Traction Control › Brake Control System - Service Information › Downhill Assist Control Switch › Inspection [08/2015 - ] › Procedure

Inspection [08/2015 - ]: Procedure

  1. CHECK DOWNHILL ASSIST CONTROL SWITCH 
    1. Measure the resistance according to the value(s) in the table below.
      GTY703176Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Standard Resistance

      Tester Connection Switch Condition Specified Condition
      1 (E) - 4 (+B2) Pressed Below 1 Ω
      Not pressed 10 kΩ or higher
      TEXT IN ILLUSTRATION

      *a Component without harness connected
      (Downhill Assist Control Switch)

      If the result is not as specified, replace the downhill assist control switch.

About FixVault