FixVault
Home › Toyota › 2017 › 86 Base, Standard Trans › Repair and Diagnosis › Brakes › Traction Control › Brake Control System (Service Information) › Brake Actuator › Reassembly [06/2016 - ] › Procedure

Reassembly [06/2016 - ]: Procedure

  1. INSTALL SKID CONTROL ECU 
    1. Install a new skid control ECU so that the coils of the skid control ECU and the brake actuator valves are aligned.
      NOTE:
      • Install the skid control ECU while keeping it level by holding at the corners to prevent deformation of the skid control ECU housing cover.
      • Check that there is no dirt or foreign matter on the installation surface.
    2. Tighten the screws on the skid control ECU using the following procedure.
      NOTE:

      As the screws are not reusable, be sure to use new screws.

      1. Using a TORX deep socket wrench E5, tighten new 4 screws in the order shown in the illustration.
        GTY747256Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

        Torque: 1.5 N*m (15 kgf*cm, 13 in.*lbf) 

      2. Check that there is no foreign matter caught between the skid control ECU and the brake actuator.
      3. Tighten the 4 screws again in the order shown in the illustration.

        Torque: 3.0 N*m (31 kgf*cm, 27 in.*lbf) 

      4. Check that there is no gap between the skid control ECU and the brake actuator.
  2. INSTALL BRAKE ACTUATOR DAMPER 
    1. Install the 3 new brake actuator dampers (A and B) to the brake actuator bracket assembly.
      GTY390434Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. INSTALL BRAKE ACTUATOR BRACKET ASSEMBLY 
    GTY730286Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Install the brake actuator bracket assembly to the brake actuator assembly with the 3 new nuts and 3 new washers.
      NOTE:

      Do not remove the hole plugs of a new brake actuator assembly before connecting the brake lines because the brake actuator assembly is filled with brake fluid.

      Torque: 7.5 N*m (77 kgf*cm, 66 in.*lbf) 

About FixVault